If you’ve ever wondered why your hot springs hot tub is blinking, you’re not alone.
While the answer may seem obvious, there are actually a few different reasons why this could be happening.
Let’s take a look at a few of the most common reasons why your hot springs hot tub may be blinking.
One of the most common reasons why your hot springs hot tub may be blinking is because the water level is too low.
When the water level in your hot tub gets too low, the pump can’t circulate the water properly and the heater will shut off.
This can cause the hot tub to blink.
Another common reason why your hot springs hot tub may be blinking is because the temperature is set too high.
If the temperature in your hot tub is set too high, the thermostat will turn the heater off.
This can also cause the hot tub to blink.
The last common reason why your hot springs hot tub may be blinking is because the filter needs to be replaced.
If the filter in your hot tub is clogged, the water can’t flow through it properly and the hot tub will blink.
If you’re not sure why your hot springs hot tub is blinking, the best thing to do is to call a technician.
They’ll be able to diagnose the problem and give you the best course of action to take.
How do you reset a Hot Spring hot tub?
It’s easy to forget just how relaxing a hot tub can be until you jump in and feel the heat envelop your body. That’s why it’s important to keep your hot tub in good working condition so you can enjoy it for years to come.
If you’re having trouble with your Hot Spring hot tub, resetting it may be the answer. Here’s a step-by-step guide on how to do it:
- Unplug the power cord from the outlet.
- Remove the filters and clean them according to the manufacturer’s instructions.
- Close the hot tub’s drain valve.
- Fill the tub with fresh water.
- Add the correct amount of water treatment chemicals.
- Turn on the power and let the tub run for a few minutes.
- Test the water to make sure it’s at the right temperature and pH level.
- Enjoy your reset hot tub!
Why is my Hot Springs hot tub flashing yellow?
There are a few different reasons why your Hot Springs hot tub might be flashing yellow, but the most common reason is that the water temperature is too high.
If the water temperature is above 104 degrees Fahrenheit, the yellow light will start flashing.
This is a safety feature that is designed to protect you from overheating.
If you see the yellow light flashing, you should immediately turn off the power to your hot tub.
Once the power is off, you can safely enter the tub and lower the water temperature.
To do this, you’ll need to find the thermostat on your hot tub and turn it to the “off” position.
Once the water temperature has been lowered, you can turn the power back on and the yellow light should stop flashing.
